1969 Ford Bronco

2 door

302 V8

Standard

Clear

GAS

1969 Ford Bronco 4wd This Bronco has been my baby I am forced to sell because two recent surgeries. To start it has 5 inches of lift with suspension and body lift. It has brand new wheels and tires no miles just rolling in and out of garage tires are BF Goodrich. This is a rust free bronco their was minor rust in the floor pans and sheetmetalthat has been cut out and replaced. It has brand new painless wiring that need to be installed, new black vinyl seats ,new roll bar new interior is diamond plate door panels.It has new windshield with rubber and all new door wipes and seals still in the box. I have all new trim such as interior and exterior door handle new head and tail light bezels. The speedometer has been rebuilt and painted. I have all new door seals also. The hood is custom fiberglass hood with scoop .As i Stated earlier all suspension has been replaced with new springs shock and stabilizer. All brake line in front are new and been extended. I have made new custom off road bumpers for front and rear, which include D rings in front and and an area for winch also back bumper has built in receiver for hitch and they have been coated. I just painted the bronco midnight black and everything is still taken off from paint job only the front fender on drivers side has been polished out the rest of the vehicle need cut and polished. If you dont like the black you can change the color. I have a ton of work and time and money into this project. The engine is a 302 out of a 1970 bronco it has about 15,000 miles on it since rebuild the inside is clean. I have brand new edelbrock 4 barrel intake and Edelbrock 600 CFM carburetor combination on it. It has brand new HEI ignition. All bolt on accesories are new the chrome alternator and chrome valve covers are showing some minor surface rust. The radiator was rebuilt before I tore the Bronco down. The interior has been sprayed with liner coating. I have boxes of new parts including interior trim parts. The only thing this project will need is to have the driveshaft extended about two inches or you can buy a new one for about 300.00 if i remember correct all parts have been ordered from bronco graveyard and bronco specialty stores. I have over 18,000.00 invested someone is going to get a deal. I could sell for more than I am asking but I cannot finish it. I have also made two custom skeleton hands for the steprails. If you have any questions Shane 1(409)750-1905. I am sure I am forgeting some new parts not listed. Also have more chrome goodies like new chrome oil pan that has not been installed.Also the vehicle has been undercoated and it also comes with the hard top it is in grat condition with minor surface rust and a few minor dings on the top.