2003 Ford Mustang

SVT Cobra Other

4.6L 8 Cylinder Gasoline Fuel Supercharged

Manual

1fafp48y13f366919

Clear

Rear Wheel Drive

Gasoline

Power Windows

This is a 2003 Zinc yellow clear Coat mustang that was built in January of 2003. I am not goin to try to hide any flaws in the car, it does has a dent rite above the gas cap on the passanger side but will be a easy fix and the headlights over the years are a little dingey but not bad and there is a LITTLE dent rite on the tip of the top of the driver door, I have done alot of modifications to the car and hate to sell it but trying to pay off all the bills, Here are a list of the modifications done to the car, I may be leaving some of them out. The Interior of the car has a Pioneer P-3100 Double Din In dash DVD/CD Player with Ipod connection and RCA jack's for a PS2 OR whatever gameing system of your choice to put in it, It has a Pro 5.0 Short Throw Shifter, The subwoofer and amp is optional but i will charge a little extra to leave it in but it has a Memphis 1,100.1 MC Class amp with a custom ABC ported Box with a Memphis Audio 10in Subwoofer and all Memphis Audio Wiring and tinted windows and a 2 gauge dash pod with a Boost Gauge and a Innovative Motorsports WideBand, that is pretty much for the inside, i am sure i am leaving some stuff out. Here is the list of the exterior and engine modifications, 18x9 Front Black Salleen Wheels and 18x10 Black Salleen wheels, SCT Xcaliber 3 programmer with 3 Bama custom tunes on the programmer, 1 for everday driving 1 for street and some strip racing and 1 for just drag strip, the first 2 tunes use high octane pump gas but the other tune just for the drag strip it has to be high octane race fuel, It has a Fluidyne heat exchanger to help keep the heat down on the stock Eaton supecharger, The exhaust is stock headers with Pypes offroad race xpipe 2.5", with 16in Magnaflow Bullet Mufflers, The Supercharger Pulley has been changed to a 2.76 Steeda Blower pulley with matching Idler Pulley, The intake is a K&N intake. The transmission has just been redone, i broke the input and output shaft so i went ahead and beefed it up so it wont break again, It has a Liberty Gear 26 Spline Input Shaft with a Spec Stage 3 full Clutch and a Fidanza Flywheel With Removable center so the whole flywheel will never have to be replaced. That is all of the Mods i can think of at the time, This is one wicked Terminator I hope it will end up with a good home. If there are any questions you can contact me at 318-376-6993 at anytime, if there is no answer please leave a voicemail, IF SOLD SHIPPING WILL BE LEFT COMPLETELY UP TO BUYER, I will bring it to a truck to be shipped other than that it will be the buyers responsibility