1986 Dodge

150 Pickup truck

Automatic

1b7hd14h6gs065253

Gasoline

Hello, and thank you for looking at my dodge truck. Its really not much but it works. I drove it on a 240mi trip for its maiden voyage and did fine. The steering was alittle scary, so I put new ball joints, repacked front bearing, and new steering shaft damper. It still needs an alignment though. It has the die-hard inline 6cyl and an automatice 3spd. It gets about 22-24mpg on the highway. Its a long bed 2wd. The seat has tear in seam, and radio does not work. No a/c or and assesories. The drivers door is hard to close, i think it may need new door pins and bushings those are cheap though, that and i can usually get it shut on the first try. Its a baseline truck. Not sure of exact miles id say its probably rolled over, but who knows. Carb has been rebuilt,new battery and all new cables, tune-up and oil change has been done. Runs OK. not the greatest but I drive it every now and then to work to haul stuff. I really just used it to haul wood from one side of the yard to the other. I noticed the brakes on the front need done and the brake hose in the back is leaking. It would be a good farm truck/ work truck. Or if u wanted to put alittle money into it, a road worthy daily driver. As you can see from the picks it rusty, all over really, floor, bed, ect. The exhaust is leaking up by the manifold also. Like I said not the greatest but it works, I know because I still drive it to and from work once a week(40mi) I just cant stress enough i AM NOT GOING TO TELL YOU TO GET IN IT AND DRIVE 2000MI, IT NEEDS WORK! good luck I can deliver for a fee depending on how far away, call me and we'll set somthing up.309-825-2415 anytime TAKE NOTE!! Could use front brakes, little low on pad life. The u-joints r starting to make noise to, ill lower the starting bid because of the u joints. Can get them for like 20-30bucks. THANKS