1960 Chevrolet Suburban

Panel Truck

5.9 Cummins 12V Diesel

47RE 4 Speed Overdrive Automatic

0C145B114715

Clear

Diesel

1960 Chevy panel truck project includes: - Complete 1960 short wheelbase panel truck body - Professionally shortened and step notched 1997 Ram 3500 chassis - Drop front lower control arms and coil springs. Rear has been axle flipped, hangers and shackles relocated. - New steering box, ball joints, tie rods, brake pads, rotors, etc. - Complete good running 1997 12 valve Cummins with new ARP head studs, new OEM Cummins complete engine gasket set, new DDP 024 delivery valves and new DDP rack plug all new in box. Also includes Borg Warner s475 1.32 a/r turbo for twin setup, Banks twinram intake manifold, new T6 flange and gasket. Add injectors of your choice and make an easy 600+ HP. - 47RE transmission. All of the following parts are new in box from Revmax Transmissions: Revmax stage 5 billet triple disc torque converter, full rebuild kit including Alto red eagle frictions and Kolene steels with extras for appropriate clutch packs, billet apply lever, billet anchor, billet 2nd servo, billet low/reverse servo, billet accumulator, billet band strut, billet apply piston, billet intermediate band, Transgo manual valve body kit, heavy duty flexplate. - Dana 80 with limited slip and 4.10s This is currently a project and will require some assembly and fabrication. Anything and everything that I have associated to completing the panel truck will be included with sale. The dodge was a running/driving truck and the panel was complete minus the drivetrain when I got them. The panel body is currently sitting on the shortened Ram frame. The motor and trans are currently out and the front clip is off as can be seen in the pictures. I have all receipts for the new parts as well as a clear Florida title for the Ram donor truck and both Georgia and Florida bills of sale for the panel because Georgia does not title vehicles of that age.