1951 Ford Other

Sedan

8BA Flathead

Manual 3 speed

B1LU102730

Clear

Gasoline

- Original 8BA Flathead V8 and 3-speed. Runs great, but burns a little oil (original motor). It does have borg-warner overdrive, but the solenoid doesn't work so that will need to be rebuilt or replaced. - Top has been chopped 4 inches total. All new custom glass (except rear window). Garnish moldings have also been chopped to match. There is no headliner installed, but I still have the original bows.- Headlights and taillights are frenched, halogen headlights, shaved moldings, shaved door handles, shaved gas door, shaved trunk lid.- New dual exhaust with flex bellows on both sides. They are side exit through the rear body panels just before the rear wheels.- New Coker wide white walls & Black steel wheels.- Full 12 volt conversion with 12v alternator, coil, wires, plugs, and all new wiring, fuse boxes, etc.- remote door poppers with keyless entry remotes. Power windows (front) with crank window switches. Hidden trunk release. New Optima AGM battery and cutoff switch relocated in trunk.- Trunk floor sheet metal completely redone. New Mustang gas tank under trunk floor in sub frame (low profile 18 gal). - Triangulated 4-link rear suspension with 2600lb air bags and shocks. 440 compressor, 3 gallon tank, dual switches and gauges under dash.- Front 2500lb airbags, Fatman lowered uprights, new tierods, new brake cylinders, all new brake lines.- I have not installed shocks in the front yet. Also it will need a front end alignment to be drive-able.- JL Audio 10" sub and Zeus 5 channel amp in the trunk also. Currently no other speakers yet. Factory radio still in place, but will not work because it's 6 volt.- Gauges are not working (6 volt), but I have a ballast resistor for them. Not sure if they work or not (they were never wired when I got the car). The speedo doesn't work, but I think the cable just needs to be replaced. As such, the odometer reading is not accurate. No idea what the original miles are.- There is still a fair amount of rust in spots and will require more body work and obviously paint, etc. The frame is still fairly rusty, but seems solid. - Parking brake needs to be replaced. - Interior is all there (except head liner) but is obviously NOT in perfect condition. I did replace carpet with new molded oem replacement carpet. This is still a project, but most of the hard/expensive stuff has already been done. * Local pickup only, or you will need to make your own shipping arrangements.* Only PayPal or Cash accepted. Let me know if you have any questions. I'm sure I'm forgetting a few things (I've done a lot of work to it over the past couple of years). Thanks.