1979 Ford F-250

Ranger Pickup truck

8 - Cyl.

Manual

Gasoline

truck is for sale locally, i reserve the right to end the auction at anytime and make sale to a local buyer before an ebayer even if BIN has been used. depending on final price i have a spare rust free tailgate, dennis carpenter cab corners, nicer spotlight, and a set of 33x12.50x16.5s on wagon wheels 9.75x16.5 i will include to the buyer. F26SNEG4150 is the Vin drivetrain: limited slip dana 60 rear dana 44HD front axles newer lock out hubs 4.10 gear ratio, T18 4 speed trans with granny 1st, new process 205 transfer case. power steering etc, has the rare sport wheel as you seen on ebay, also has the even harder to find manual floor shift tilt power steering column. engine: 400ci edelbrock 600 elec choke carb, edelbrock performer intake, new hooker comp long tube headers and mid pipes, took the rest of the exhaust off for my 68, new top end gaskets valve cover, head, intake etc. newer reman starter. reman dual piston caliper front brakes with new pads, all new rear drum brake parts, drums, shoes, springs, wheel cylinders etc, just installed brand new set of stainless steel hard brake lines from the MC to the rear have all new rubber ones for the front installed the rear one need to install one hard line on the front passenger side, new reman master cyl, new reman brake booster, 3 inch body lift, urethane body mount bushings, has the through cab spotlight on the driver side (have a nicer one for it) all new shocks and steering stabilizer, air lift air bags on the rear springs, borgeson HD steering shaft, and im sure things im forgetting. rust and what not.....clutch does slip not sure if it on its way out or what, might need front cab mounts they look solid to me, both side floor pans are rotted through on the outer portions, cab corner on pass side (not rotted but damaged) pass side door is dented. thats the worst of the problems. the bed floor on the box is bad i replaced the box a couple years ago, the bed on the old box i had was great sides were junk though, so i POR-15'd both of the floors cut out the good floor and bolted the good one over the bad and so far everything is still solid never had a chance to get it welded up the rest of the bed is very solid. truck is sitting on 35x12.50x16.5 BFG mud tires On May-20-11 at 17:34:32 PDT, seller added the following information:if truck does not sell by end of auction it will go to the junk yard for scrap i'd hate to do it but i do not have the room or time to complete the truck.