1957 Chevrolet Bel Air/150/210

CONVERTIBLE

283 CID V8

VC57T256174

Clear

Gasoline

1957 CHEVY BEL AIR REAL CONVERTIBLE, ONYX BLACK /RED/SILVER V8 CAR PROJECT, I HAVE OWNED SINCE 1/6/2005,(PURCHASED IN VA) CAME OUT OF CINDER BLOCK BUILDING, CONCRETE FLOOR, IT HAS BEEN IN STEEL BUILDING CONCRETE FLOOR IN FL. SINCE. TITLE IS CLEAR IN MY NAME. 283 V8 ( MID 60S), ORGINAL CAST IRON POWERGLYDE AUTOMATIC TRANSMISSION, AND STOCK REAR END.(DRIVESHAFT OUT OF CAR,PICTURED, WILL BE IN TRUNK)THE MOTOR HAS NOT RUN SINCE I HAVE HAD IT, FREEZE PLUGS REMOVED PREVIOUS OWNER. FIREWALL PLATE STYLE 57 10670TX, BODY NO L33400,TRIM 683 (Red/Silver), PAINT 793 (Onyx Black), ACC BLANK DOOR JAMB PLATE VC57T 256174 ALL EXTERIOR STAINLESS IS INTACT AND STRAIGHT , A FEW MINOR DINGS ON A FEW PIECES. THE BODY FLOOR PAN HAS HAD METAL PATCH PANELS INSTALLED PRIMED ON TOP, BOTH SIDES OF FLOOR, INNER AND OUTER ROCKERS,LOWER FRONT QUARTERS BOTH SIDES,LOWER REAR QUARTER PASSENGER SIDE,REAR TAILPAN,BRACE, ALL PRIMED OR PAINTED, NO BONDO NO SEAM FILLER AND TOP PART OF TRUNK FLOOR TO CURVE,BOTH CURVES INSIDE AND OUTSIDE.TRUNK HAS FLOOR METAL PATCH ON DRIVERS SIDE( UNDERNEATH HAS A WEAK SPOT WITH ABOUT A 6 INCH SQUARE HOLE THAT WAS NOT CUT OUT ,( NEW METAL PUT ON TOP BACK IN THE DAY,GAS TANK PROBABLY WAS IN CAR)ALL BODY MOUNTS AND HARDWARE REPLACED WITH NEW PARTS. CONVERTIBLE BODY DRAIN FOR CONVETIBLE TOP HAS BEEN REPAIRED POORLY,PICTUED (THEY ARE NOW MAKING THIS PART IN 3 PCS OFFERED ON EBAY)FRONT FENDERS HAVE PATCH PANELS LOWER BOTTOM,DRIVERS FENDER HAS METAL REPAIR AROUND HEADLIGHT. THE HOOD AND DECK LID BOTH SOLID , AS ARE BOTH DOORS . THE ONLY RUST I HAVE FOUND ON CAR IS TRUNK FLOOR UNDER METAL PATCH, GAS TANK AREA DRIVERS SIDE ABOUT 6 INCH SQUARE. AND FRONT OUTSIDE AREA OF FLOOR BEHIND INNER FRONT FENDERS BOTH SIDES A DOUBLE PANEL ABOUT A 4 TO 5 INCH SQUARE ON BOTH OUTSIDE NEXT TO FIREWALL PICTURED, AND 2 SMALL AREAS ON THE TOP FRONT METAL HEADER (ABOUT 1 INCH BY 2 INCHES ON BOTH ) PICTURED ALL CONVERTIBLE PARTS INTACT EXCEPT POWER TOP PUMP AND RAMS WHICH ARE IN BOX AS PICTURED ALL STAINLESS ON CAR, MISSING POWER TOP SWITCH (THEY HAVE STARTED MAKING THIS PART) AND CURVED STAINLESS PIECE THAT GOES BEHIND REAR VIEW MIRROR, AND MIRROR WILL NEED TO BE PURCHASED. ALL INTERIOR PANELS AND SEAT SPRINGS ARE MOUNTED AND OR PICTURED(BOTTOM OF BACK CURVED REAR PANELS BOTH NEED METAL REPAIR AT BOTTOM OF PANEL APRX 3 INCHES. FRONT SEAT SIDE COVER HAS SOME METAL THAT NEEDS REPAIR ON PASSENGER SIDE.( AN E XTRA ONE FOR REPAIR PANELS IS INCLUDED AND PICTURED) FRONT DOOR PANELS AND BACK PANELS WITH STAINLESS,ARE OFF CAR PICTURED, AND IN TRUNK,FRONT ARM REST METAL PICTURED AND WILL BE IN TRUNK IN BOX SIDE GLASS IS OUT AND PACKED IN A BOX 4 FRONTS, 2 REARS AND 2 VENTS(PICTURED AND WILL BE IN BOX IN TRUNK), REMOVED FOR PICTURES, BOTH REAR WINDOW GEAR ARMS OUT AND PICTURED(IN BOX AND IN TRUNK).DRIVERS DOOR HAS DOOR GLASS GEAR AND VENT GLASS GEAR, PASSENGER DOOR HAS NEITHER. BUMPERS,HEADLIGHT RIMS TAILIGHT HOUSINGS ,HOOD SPEARS, GOLD ITEMS, MESH IN GRILLE ARE DRIVER QUALITY, THE GRILLE CENTER BAR IS SHOW QUALITY WITH A GOOD POLISH. ALL 5 WHEELS ORIGINAL WITH TABS FOR ORIGINAL 4 HUBCAPS, JACK IS IN TRUNK NEW REPO ONE OF FRAME MOUNTS ON PASSENGER SIDE IS BENT AND NEEDS TO BE REPAIRED AS PICTUREDRADIATOR IS 57 BUT ORGINALLY A 6 CYLINDER MOUNTED IN V8 POSITION,NEW BATTERY TRAY INSTALLEDAIR DUCTS NOT MOUNTED, IN BOX IN TRUNK, AS PICTUREDBOTH INNER FRONT FENDERS HAVE HAD METAL REPAIR AND ARE SOLID DOOR,TRUNK AND EXTRA IGNITION SWITCH ALL USE ONE KEY , 2 KEYS INCLUDED AND EXTRA IGNITION SWITCH IN GLOVE BOX WITH RADIO BESELS AND KNOBS AND KEYS,DASH ITEMS COMPLETE AS PICTURED CONVERTIBLE TOP FRAME ALL INTACT AS PICTURED, FRONT METAL CURVED HEADER PIECE THAT GOES AGAINST WINDSHIELD NEEDS 2 SMALL AREAS REPAIRED ABOUT 3 X 1 INCHES LONG ON EACH SIDE AS PICTURED THE ONLY BONDO I HAVE FOUND ON CAR IS A SKIM ON TRUNK SIDE WALLS AS PICTURED BOTH SIDES (OLD METAL REPAIR IN THIS AREA ON BOTH SIDES AS PICTURED)NO SEAM FILLER ON WELDS ON FLOOR, TOP OR BOTTOM, NO BONDO ON QUARTERS, AND ROCKERS, TAILPAN AND FENDER REPAIRS....... THE CAR HAS NO BRAKES,AND DOES NOT RUN, ALL BRAKE AND GAS LINES NEED TO BE REPLACED, GAS TANK AND STRAPS ARE GOOD DRIVER QUALITY AND TANK IS DRY AND DOES NOT LEAK, CAR ROLLS ,HEAVY EXCELLENT SOLID PROJECT WITH A LOT OF WORK ALREADY DONE, MISSING VERY FEW ITEMS, SELLING BECAUSE I HAVE TOO MANY PROJECTS CAR AND TITLE WILL NOT BE RELEASED UNTIL I HAVE CASH IN HAND.BANK WIRE TRANSFER ACCEPTABLE.(USUALLY TAKES UP TO 4 DAYS) 500.00 DEPOSIT THRU PAY PAL. DUE END OF AUCTION, CAR MUST BE PAID FOR AND PICKED UP 7 DAYS.......... CALL PAUL AT 904-742-6449 EASTERN TIME ZONE, FOR MORE PICTURES OR QUESTIONS