1969 Dodge Dart

Sedan

6.3L 6286CC 383Cu. In. V8 GAS OHV Naturally Aspira

Automatic

LL23A9B444781

Clear

GAS

Ok little info on the car Clean florida title in my name. --Engine / transmission Running mopar 383 big block Brand new Hedman hustler fender well headers Brand new intake filter Brand new electric water pump Brand new 120 amp denso 210-0138 alternator (to run more electronics) Brand new timing cover Brand new set of Lokar throttle and kickdown cable Brand new Speedo cable Brand new mopar mini starter Brand new optima battery and battery box Brand new starter relay Brand new edelbrock 1407 carb, no fuel ran through yet All brand new seals Msd pro billet distributor with 6a box and coil blaster Edelbrock 383 torker manifold Moroso deep oil pan --Tranny was rebuilt with fresh stall Brand new stainless cooler lines with new fittings Brand new B&M trans cooler --Interior Brand new flaming river steering column with tilt Brand new flaming river steering wheel adapter Brand new Lecarra steering wheel Brand new set of rocker switches for fans, water and fuel pump Brand new set of 6 autometer gauges with led lit lights Brand new carpet Brand new headliner Brand new armrest sets Brand new hurst v matic shifter Brand new door handles Brand new door sills Brand new trim pieces Brand new custom solid door panels Brand new recovered dash pad Brand new wire harness throughout the car with essential relays in the needed spots such as headlights, fuel pump, starter, fans etc.. All given the correct fusible links and all crimped, soldered, and heat shrunk correctly. Custom aluminum dash panel insert Dashboard and interior pieces sprayed with the bed liner given a nice finish. Interior is 95% complete and new aside from the seats. The vinyls have not been ordered yet. The skeletons of the seats however have been sandblasted, primed and painted black to prevent oxidation. They are covered with foam and awaiting covers. --Fuel delivery Brand new JAZ racing 16gal fuel cell with fuel level All brand new stainless braided fuel line to the carb All brand new fittings Brand new fuel filter Holley blue racing fuel pump Brand new summit racing fuel pressure gauge --Under body Underneath the car was wire brushed and also given a bed liner treatment with UPOLS raptor liner from front to back -- suspensionRotor brakes in frontBrake have not been purchased for rear yet Stock front suspension with big bolt disks Rear has a chassis engineering ladder bar suspension with strange coil overs. Stock length true A body 8 3/4 rear end with a 742 third member The 742 third member has 4:10 Richmond gears and a Mark Williams heat treated 35 spline solid spool Axles are a custom set from Dutchman Axles with 4.5 bolt pattern and 3 inch studs. COMPLETE REAR END IS BRAND NEW WITH 0 MILES. (New gaskets, bearings, hardware) -Wheels and tires Weld wheels front and back, skinniest the front I think 15x5 and 15x8in the rear. I did a mini tub to it already as I planned to put 325/50/15 on a set of 15x10 welds. --Exterior Brand new fiberglass 6 pack hood uncut no holes drilled for hood pins yet. Brand new fiberglass deck lid not mounted and trimmedBoth hood and trunk lid are as I received them from USBody Brand new front and rear windshield seals with new clips Body is in great condition with a few more minor spots to touch up such as the trunk gutters and other small areas which was my next step on the body. Just needs to be painted/body work. I planned for it to be a driver, not a trailer queen. While the car is listed, I will still continue the process of working on it and getting it back together. So I'm in no rush to sell whatsoever. Vehicle is also listed locally so I have the right to end auction at any time. Doesn't need a lot to complete, and will definitely be a head turner when done. Thanks for your interest. On Sep-06-14 at 13:07:44 PDT, seller added the following information: Ok little info on the car Clean florida title in my name. --Engine / transmission Running mopar 383 big block Brand new Hedman hustler fender well headers Brand new intake filter Brand new electric water pump Brand new 120 amp denso 210-0138 alternator (to run more electronics) Brand new timing cover Brand new set of Lokar throttle and kickdown cable Brand new Speedo cable Brand new mopar mini starter Brand new optima battery and battery box Brand new starter relay Brand new edelbrock 1407 carb, no fuel ran through yet All brand new seals Msd pro billet distributor with 6a box and coil blaster Edelbrock 383 torker manifold Moroso deep oil pan --Tranny was rebuilt with fresh stall Brand new stainless cooler lines with new fittings Brand new B&M trans cooler --Interior Brand new flaming river steering column with tilt Brand new flaming river steering wheel adapter Brand new Lecarra steering wheel Brand new set of rocker switches for fans, water and fuel pump Brand new set of 6 autometer gauges with led lit lights Brand new carpet Brand new headliner Brand new armrest sets Brand new hurst v matic shifter Brand new door handles Brand new door sills Brand new trim pieces Brand new custom solid door panels Brand new recovered dash pad Brand new wire harness throughout the car with essential relays in the needed spots such as headlights, fuel pump, starter, fans etc.. All given the correct fusible links and all crimped, soldered, and heat shrunk correctly. Custom aluminum dash panel insert Dashboard and interior pieces sprayed with the bed liner given a nice finish. Interior is 95% complete and new aside from the seats. The vinyls have not been ordered yet. The skeletons of the seats however have been sandblasted, primed and painted black to prevent oxidation. They are covered with foam and awaiting covers. --Fuel delivery Brand new JAZ racing 16gal fuel cell with fuel level All brand new stainless braided fuel line to the carb All brand new fittings Brand new fuel filter Holley blue racing fuel pump Brand new summit racing fuel pressure gauge --Under body Underneath the car was wire brushed and also given a bed liner treatment with UPOLS raptor liner from front to back -- suspensionRotor brakes in frontBrake have not been purchased for rear yet Stock front suspension with big bolt disks Rear has a chassis engineering ladder bar suspension with strange coil overs. Stock length true A body 8 3/4 rear end with a 742 third member The 742 third member has 4:10 Richmond gears and a Mark Williams heat treated 35 spline solid spool Axles are a custom set from Dutchman Axles with 4.5 bolt pattern and 3 inch studs. COMPLETE REAR END IS BRAND NEW WITH 0 MILES. (New gaskets, bearings, hardware) -Wheels and tires Weld wheels front and back, skinniest the front I think 15x5 and 15x8in the rear. I did a mini tub to it already as I planned to put 325/50/15 on a set of 15x10 welds. --Exterior Brand new fiberglass 6 pack hood uncut no holes drilled for hood pins yet. Brand new fiberglass deck lid not mounted and trimmedBoth hood and trunk lid are as I received them from USBody Brand new front and rear windshield seals with new clips Body is in great condition with a few more minor spots to touch up such as the trunk gutters and other small areas which was my next step on the body. Just needs to be painted/body work. I planned for it to be a driver, not a trailer queen. Res 65OO While the car is listed, I will still continue the process of working on it and getting it back together. So I'm in no rush to sell whatsoever. Sold as is Vehicle is also listed locally so I have the right to end auction at any time. Doesn't need a lot to complete, and will definitely be a head turner when done. Message for ANY questions about the vehicle! Will give any knowledge that is possible about it. Thanks for your interest.