1967 Chevrolet El Camino

SS Clone El Camino

350 SBC

Automatic

136807b185065

Clear

Gasoline

Due to many questions, I will try to answer as best I can. The hard work has been done, right and left quarters, inner wheel wells, and lower rockers. Solid frame and floors, tail gate, glass, and all trim is there. Front floor tunnel will need to be patched, or install a 4 speed, (has two new floor panels to use as patch panels. The front and rear glass is not installed, but the front glass is laid in the opening until painted. The vehicle runs and drives, great father and son project! Has bench seat, (will need to be recovered). Also included, 1967 - 1968 Camaro bucket seats, very good condition (if you prefer bucket seats over the bench seat). Has a second SS hood, solid doors and very nice SS hood installed with vehicle. Has rear air shocks, with power drum brakes, tilt column, 10 bolt rear, and power steering. I purchased this vehicle with great hopes, but just have to many projects, and must sell, (my loss your gain). Clear title in hand. Vehicle does run and drive. Chevy small block 350 (casting # 3970010) Turbo 350 automatic trans. The exhaust manifold is leaking on the left side, gas pedal should be replaced, (aftermarket pedal in the shape of a foot), and brake pedal goes to the floor, but does stop, (possible brake booster, not sure). This vehicle has huge potential with little work left to do, ready for your color! Thank you for looking. Please call between 6pm - 11pm - Monday - Friday, and anytime after 7am on the weekends. .Note: I do have a video of the vehicle running that I can send to e-mail or cell phone. Duane H. 443-864-3011