1976 Datsun Z-Series

Coupe

2.8L

Ma

Rebuilt, Rebuildable & Reconstructed

Gasoline

Its time to part with my first restoration project after rebuilding for 4 years now. I've done some extensive body work over a 4 year time period. I've installed Corvette lights due to previous owners decision to cut out back end. I've repaired the passenger rear quarter panel. I've repaired the floor pan for any rust. Still has a rust issue on behind the driver door. typical rust, I have replacement panel for this fix as well. You would need to install the front coil over perches for the coil overs, i have front coils still on Oem perches. i installed a couple years back. I've removed broken AC unit, belts, wiring etc. I installed the Arizona Z Holley intake manifold, along with the Holley 390 CFM Carb. I have Installed a 6 to 1 header with MSA exhaust system. it sounds great! Speedometer currently inst working since last year it stopped at 43k miles. Rev meter works fine along with oil pressure, water temp, and new quartz clock. The Z runs strong just needs a good home of an enthusiast. I don't have the title, only bill of sale. that was the last step for me to get her back on the road. I haven't had time to finish my project and money is tight so I'm open to some reasonable offers. I'm really looking to get my money back. If you have any questions, feel free to contact me. Features includes: Stainless steel brake lines Coil overs New sway bar bushings Front air dam Adjustable bucket seats Corvette taillights Fender Flares 1 inch spacers 15 inch Steelies Cold air Intake Holley 390cfm Carb Arizona Z intake manifold 6 to 1 Header MSA Exhaust system New head gasket New timing belt New timing chain  New distributor cap New MSD ignition coil New Fusible Link setup Fender Mirrors Rear Louvers (Not Pictured) New Door Locks New Quartz Clock Newer Radiator (OEM) New Headlighs New brake booster New clutch slave cylinder Needs: Weather stripping Professional Paint Interior work I'm open to some reasonable offers, please no low balling.