1975 Triumph TR-6

Convertible

CF38181U

Clear

Gasoline

This is a project car that I bought last year, but have found I don't have the time to restore it. The vehicle has 42,516 original miles, but was put in storage and ignored for 10 years, and now has extensive rust. The engine runs but the throw out bearing is frozen so the car is not drivable. It does however roll so it can be moved about.I have an entire new clutch including friction plate, pressure plate and throw out bearing that needs to be installed.The engine has a new fuel pump and filter, a new thermostat, and a new clutch master cylinder. I have new radiator hoses that need to be installed. It has electronic ignition. The floor pans, rocker panels and the rear deck are rusted and need to be replaced.I have new floor pans, rocker panels with end caps, and rear deck panel, these all need to be installed. Also have a new front valance finisher bar.This is over $1,500 in new parts. There is rust at the bottom of the doors and some on the fenders and trunk lid that needs to be repaired and can be seen in the pictures. I have started a lot of disassembly, all parts are boxed and labeled for reinstallment. The seats are in good condition, no rips or tears. Performed a compression test today with the following results, 1=130, 2=130, 3=120, 4=120, 5=127, 6=135.