1988 Ford Mustang

LX Coupe

331

Manual

1FABP40A7JF129328

Clear

GAS

This is my current drag car project up for sale. This car is one of the cleanest bodied Fox chassis mustangs you will find in the northeast. It was a factory 4 cylinder car that I converted back in the early 2000's. It was painted in 2005 and has been secure in my garage since then. it has never seen rain or snow and is absolutely 100% rust free. I installed a high compression 331 stroker back in 2009 and it has about 150-200 miles on it since then. It has been taken down the track about 25 times all of which are available for viewing on youtube if you search user lebanon46gt. It has never been professionally tuned since the install and still runs a respectable 11.60@120. The car has a multitude of add ons including but not limited to the following: CHP 331 strokerPorted, polished, shaved 351W cast iron heads SPEC Aluminum flywheelRAM Clutch 900 seriesUPR K member, A arms and Coil oversUPR Manual brake kitPro Shifted T54:10 rear with Auburn Pro diff and 31 spline axlesFRPP Aluminum driveshaft. KONI shocksMAC Control arms. FRPP GearsWeld WheelsMickey Thompson 26x10.5x15 ET Drag SlicksMickey Thompson Sportsman SkinniesPro 5.0 ShifterEdelbrock Victor 5.0 intakeC&L 80 mm MAFMAC cold air intakeHooker Headers (equal length)off road H pipeFlowmastersA9L computer with TWeecer Much More. The car has NO Interior. There is 1 seat and a steering wheel. No heat NO AC No Wipers No wiper motor. Its a Drag Car!! This is not for street use in its current configuration. There is a short belt setup with no accesories, just crank pulley, water pump and alternator. It will overheat if street driven. Must be run on VP 104. It has 13:1 compression. Pro Shifted trans is for off road use only. The title is clear and if you choose to equip it properly, it could be converted to a street car. It must be trailered. You can call me with any questions at 860-208-0875. Thanks!!