1969 Ford F-100

390 ranger trim Pickup Truck

390

Manual

Clear

Gasoline

Hi Ya'll, This is a 1969 Ford F100 1/2 ton truck but has a Dana 60 rear axle that is a regular 5x5.5 ford lug pattern from the factory, we removed the three speed trans and installed a 4-speed granny gear trans too make the drive trans bullet proof. Yes it runs and drives but has no brakes so it will need to be trailered away. This is a list of new parts we have installed when we bought her. 1)new clutch assembly-clutch, pressure plate,flywheel,throw out bearing and pilot bearing. New used 4-speed granny geared trans, tune with plugs,cap,rotor,points,wires and fuel filter with oil change and filter, air cleaning with k&n 5 inch filter, new brake master cylinder, head man headers,3 inch exhaust pipe and 3 inch cherry bomb shorty muffler's.(yes it's loud).We also changed the trans-fluid to syntec. What the truck still needs to be road ready. 1)front and rear brake overhaul,thermostat housing-(cracked),I would replace all the u-joints and carb rebuild or replaced (holly 4-bbl on it now, factory). Major concerns-rust, mainly in the roof line above the windshield and the engine's hood and the bed floor.The floors,doors,fenders and tail gate are all ok. The pictures you see on here are all I have, my camera broke so I can't get anymore, so ask all questions and as you all know there is no warranty on this ride, you buy it it's yours come get it as soon as possible, we can hold it for a while if needed but a deposit must be made and if you don't come get it when you say you will the deposit will be mine and I'll relist the truck due to selling fee's and lose of sell on your parts so if you buy it come get it.