1991 Jeep Cherokee

H/O SUV

6 Cylinder 4.0 Liter

Automatic

1J4FJ88SXML634720

4 Wheel Drive

Gasoline

Power Steering

Hi there and thanks for checking out my auction. Today up for bids is my 91 cherokee. For more photos, please click this link: http://s1181.photobucket.com/albums/x434/xj9135/ THIS CHEROKEE DOES NOT RUN. I WAS TOLD IT NEEDS A NEW WIRING HARNESS BUT CANNOT PROMISE THAT WILL RESOLVE THE ISSUE THE GOOD: A 6.5" Suspension Lift Kit Good tread on the 35x12.50 15s Flowmaster Exhaust An eye catching Allis Chalmers Orange paintjob It has an electric fan along with a manual fan to help keep it cool. My friends dad owned a small auto parts store that was shutting down so i bought and replaced the following to help him clear out the rest of his stock: Starter, Spark Plugs, Speark Plug Wires, Distributor, Rotor Cap and Button, Coil, Thermostat. Solid vehicle, no leaks or any fluid loss THE BAD: As stated, this jeep does not currently run. I bought it this way, planning to fix it but working 60 hours a week does not leave me much extra time so I am selling it so someone else can enjoy it. I was told it has electrical problems and a new wiring harness would take care of it but I cant say that will do it for sure, as I'v not had any time to mess with it and the battery has been dead since i got it. The front doors have power windows and the jeep does not have the pigtail for that but I'm sure you could buy a kit for that rather cheap? Also, I noticed that it does not have a front drive shaft, i priced a used one at a junk yard for $30. The interior is stripped of carpet and headliner for obvious reasons, but the floor is coated in black truck bed liner type stuff, and the back doors have to be opened from the outside as the door rods are disconnected currently. There is also no radio in it. I would state the exact problems it has, but I havnt had time to charge the battery to see what it will and will not do. I was just told it had electrical problems and a new/used harness would take care of it. I know there are companys out there that sell CHEAP priced motor mounts that will enable you to bolt up a small block GM 350, and GM 4.3s up if you may have one laying around. A 4.0 straight 6 is not a small sized motor, so the bay is big enough for many many V8 setups. Thanks for looking, and email me with any questions you may have and I will answer them the best I can! I prefer money order, cashiers check/bank check for payment when the vehicle is picked-up.