1969 AMC AMX

A9C397N324620

Clear

1969 AMC AMX Prostreet roller - Dana 60 with 3 point ladder bar rear suspension with leaf springs - front suspension is coil overs - Roll bar does NOT meet NHRA specs but could be corrected to do so. This is a back-halved car. It is a roller only. The interior is bare as in nothing. Fiberglass hood, trunk lid, and front bumper. Front fenders are from a 1970 AMX. Body is solid as well as floors, etc. Rear wheel wells have been opened up considerably and there is a little body work to complete them but are nicely done. Great project with the hard and expensive chassis work done. Rear tires are 31 X 16.5 and fronts are skinnies - good rubber. Thank you, Dean cell 701-205-6906 Adding a few thoughts - I have received several messages and calls. There seems to be a lot of concern on what the car is missing. Perhaps looking at what one gets is a better approach. There is $1000 worth of wheels - $800 worth of tires - what does a narrowed Dana 50 cost as well as the cost to back half the car and redo the wheel wells and a roll bar assembly. The fiberglass parts add up as well. Not to mention it is a very clean body with no major rust concerns - consider what you would pay for a solid roller to begin with. Not trying to be a butthead, just hoping folks will understand the value at only $3500 - just my thoughts be it right or wrong. I have owned dozens of AMX's and know them well - this is a good buy if you are in the market for building a hot AMX. Thank you all, Dean