1968 Chevrolet Corvette

Convertible

327

Manual

194678S402032

Clear

No RESERVE sale...1968 Corvette for sale. This is an early production convertible (402,032- which is the 2,032 Corvette off the assembly line).Safari Yellow paint code as seen by certain pictures above (984)Black Standard interior color (STD)Rear differential is an AO 68 dated rear which translates to a 370.Brakes and dust shields were new but again showing surface rust from exposure.Intentions have always been to restore this car to a non-NCRS caliber ride that could be driven and not trailered. But with three kids there just isn't the time right now. I have gathered parts, but there is still quite a lot to be found. No engine or transmission in this sale, but it would have been a 327 with manual trans.The rolling chasis was restored prior to me taking ownership of it. The frame has been blasted and coated. The front and rear suspension has been replaced, but showing signs of surface rust on bare metal pieces as seen in the pictures. The body bushing mounts still need adjustment, as does the rear suspension. New mono-spring replaced the original leaf set up.You can see in the pictures I photographed as much as I could. The only picture I did not take was of the spare tire tub which is included in the sale.New gas tank and all necessary hardware is labeled and included.New lines are along the frame and need to be tightened down.New front valance is pictured along with bumpers (front and rear).Rear tail light panel included with reverse lights and harness.Extra door handles and side marker lights complete the body and small block hood has refinished hinges attached.I do not have the front grills or bumperettes for it but do have front and rear license plate bezels and brackets.Front end bumper brackets seem all to be there but was not taking the time to set that up, as the body mounts need to be adjusted first.Headlights are complete with exception of one headlight which I believe I have laying in the garage.Front driver side fender is cracked up near gills, but I do have a GM press molded fender section if one wanted to bond it. Interior:Seats need to be restored as seen. I have some seat belt parts.Shifter console is included as is door panels that are driver quality. I have the handles and knobs.Needed would be kick panels, carpet, e-brake console, and seat backs.I have an original 68' Speed-alert speedometer that can be purchased separately if you want.What else can I say about the car? If you want NCRS restoration, then I would replace the surround and driver side fender. I have the title for the car and it is clean. Hope the winning bidder can get this back on the road in the future. Email me with any questions, as I am sure I missed some things.