1986 Ford Mustang

Coupe

5.0L V-8

Manual

1FABP26AXGF324411

Clear

Gasoline

Up for sale is a 1986 Mustang LX that came out as a 4cyl. 4 speed. It now has a 5.0L engine built at Blue Ribbon Racing in Nashville. It has been bored .030 over, Erson Cam E212832 with .512 lift 288 duration 351W heads with larger 1.84 intake and 1.78 exhaust valves. 5 speed T-5 transmission and 8.8 rear end. I had an 86 GT that was bought at an auction then found out it was wrecked and basically junk. So I found a straight body and used the GT as a donor. I have driven the car 20-30 miles since it was basically rebuilt from the ground up. There is dynamat throughout the car and more parts than I can list. Some of the parts that I have receipts for are listed below but I’m sure it’s not all. By no means is this a “new car”, it has been a project for several years and still has more potential. It needs the correct MAF sensor and a final tune but starts runs and drives. It has factory paint with some blemishes. There are some dings and dent. Only one spot near gas tank door has been repainted. I have really just lost interest in it, don't have time to mess with it and other things, but mainly just need the space. No joy rides. Sold as is where is. I will not ship. ************For sale locally auction may end at any time.*************A9L computer with Mass Air conversionFront and rear shocks, strutsBrake pads, calipers, hoses, and wheel cylindersPolyurethane Rack and Pinion BushingsPolyurethane Engine and Transmission mountsPolyurethane spring isolatorsEibach Lowering SpringJEGS Rear Upper & Lower Control Arm SetBBK Sub-frame connectorsMSD Blaster coilFord Racing wiresDistributor, cap, rotorFord Racing King Cobra clutch, fork and cable140mph speedometerAll new door and trunk seals190lpm Summit Racing fuel pump, Braided Stainless Steel fuel linesOn Oct-06-15 at 05:26:33 PDT, seller added the following information: ***I want to clarify that the transmission didn't come from the GT it was another part of it that was junk. It is the 4 cyl. T-5 with bigger input shaft.. I completely forgot about this until last night... I apologize for the confusion and please ask any questions. As stated this has been a project for several years and will make someone a great toy with a little TLC.***