1972 Triumph Bonneville

Clear

This is a custom chopper that is raked, stretched and lowered, not just your ordinary bolt on hard tail! The bike is a project bike that needs finishing, has been sitting for several years in my garage. It ran before it was chopped. New Harley drag bars and controls, custom chrome twisted wide glide springer, custom rigid frame, new Harley master cylinder and disc brake rear, jack shaft, new Excel coil and Boyer ignition, Morgo Big bore kit, used harley oil tank in good condition, custom motor mounts, kick stand and foward controls, new Avon 200 rear tire and new spoked wheel and bearings, new Avon 90 x 21 Venom front on new 21 x 2.15 spoked wheel and bearings GSXR TOKICO caliper front and rear, new seat and spring mounts, jockey shifter with 8 ball knob, new Goodman braided stainless steel brake lines, new headlight and tail light license holder. To get the bike on the road you would have to: Rebuild or replace carbs Install throttle n clutch cables (supplied) install ign switch, ign module, rectifier (supplied) Install horn Install oil lines Wire entire bike Install adjusters on jackshaft Install lock nuts or cotters all critical bolting Secure exhaust Chrome the jockey shift and brake pedal (or paint) secure fuel tank and install fuel line and hoses Might be others, but should be most