2003 Ford Mustang

Coupe

4.6L DOHC Supercharged

Manual

1FAFP48Y13F302475

Clear

Gasoline

Selling my 2003 Ford Mustang Cobra coupe. It has 51,000 miles with a clean title. The bad part is after fixing the issue about 2,500 miles ago, the car has developed a slow head gasket leak on the passenger side on #4 (same side as before). The engine has no bottom end damage and the compression is very healthy. You might be able to get away with just resurfacing that head and applying some copper head gasket spray, which I didn't use before. It has the following modifications from previous owners - - SLP long tube headers - X pipe with high-flow cats - 2.5" catback - BilletFlow plenum and single blade throttle body - BBK cold air intake - Lowering springs (not sure on the brand) - 100mm idler - Replica 17x10 chrome Cobra wheels with 275 front and 315 rear tires- Fluidyne heat exchanger Parts I've installed - - Mac mufflers and had the slip fits welded (SLP loudmouth previously) - 170 thermostat - 3.0 Metco upper pulley - Metco lower pulley with the stock diameter ring - Pro 5.0 shifter - 26 spline input shaft from D&D performance with Spec Stage 2+ clutch (less than 2,500 miles on this) - Dyno tune for 91 octane by Steve at Powertrain Dynamics, made 428/422- ARP head studs and new Fel Pro MLS head gaskets- All new engine gaskets and seals- New chains, gears, and guides- Valve job and resurfacing on heads by MMR (all the new engine parts also only have about 2,500 miles on them) The car currently runs and drives fine still and doesn't overheat, but I'd recommend trailering it until fixed. The AC blows cold. I've always garaged the car since I've owned it. I have receipts for all the parts I've installed upon request. The only additional things that need to be fixed are the third brake light (super common), the aftermarket boost gauge, the rear window tint is bubbling, and it has a scratch on the rear bumper (pictured) where I accidentally got it with the garage door wheels. I'm selling it because if you've worked on these cars before you know pulling the engine without a lift is not for the faint of heart. I simply don't have the time and patience to do the work again. Let me know if you have any further questions or need more information. Thank you for looking. **IF YOU HAVE TO PASS CA EMISSIONS I DON'T RECOMMEND PURCHASING THIS CAR **THE CAR IS SOLD AS IS WITH NO IMPLIED WARRANTIES**