Detail Info for: 1953 Hudson Hornet 1953 Hudson Hornet

Transaction Info
Sold On:
11/07/2017
Price:
$ 3550.00
Condition:
Mileage:
99999
Location:
Springfield, Missouri, 65804
Seller Type:
Private Seller
Vehicle Specification
Year Make Model:
1953 Hudson Hornet
Submodel Body Type:
Sedan
Engine:
308 cubic inch flat head 6 cylinder
Transmission:
Manual
VIN:
Xxxxxxxxxxxx
Vehicle Title:
Salvage
Drive Train:
Fuel Type:
Gasoline
Standard Equipment:
Optional Equipment:
Vehicle Detail
Runs and drives. New clutch over 1000 bucks for that. Rebuilt 308. All new front end and brakes. New electrical wiring. Not a professional restoration but fun to drive with neat patina. Wipers do not work. No battery, but I will provide one to start it. Must pick up in one month. Licensed as a 55. I will accept PayPal and help load if you have a shipper. Ask all questions first. Is a bidders onlyOn Oct-31-17 at 11:16:31 PDT, seller added the following information: this car does not have salvage paperwork. i could not find appropriate choice from drop down box. this has paperwork and i have pillar plate of 55 hornet. i still have original pillar plate and could be registered as that if you want to go thru trouble. i just want to make sure everyone understands this, as i dont want anyone to be unhappy with this car. i have loved it for years. i also thought of a few other things. i had original tank relined a few years ago.it has a 6 volt pos ground altinator, this is one thing that isnt original hudson on this car. it works great though, but doesn't look period correct. the electrical is all 6 volt pos ground. the turn siganls are not hooked up. i never did this when i did the wiring. i have never tested the swithch on column, but it is there. the dash was cut to have a different radio installed. i found a earlier hudson radio that fit in hole, buy it does not work, just for looks. the unibody frail and the floors and trunk are in good shape. i fixed a few small spots years ago. the front seat had new padding and was covered in a movers blanket, the rear bottom is the same. also i pieced the lower pass front door interior together off two ones, the drivers side upper front door panel is made from sheet alum, as i was going to get a replacement someday. one very small crack on one side of windshield that doesnt interfear with anything, not very noticable. all other glass is good, i think. the inner engine front panels have been trimed to get better acessed. the frame and lots of interior parts and floor was painted with por15. them some painted with matched color. im sure theres more, any questions please text me 417 773 2270 till 9pm central time with any question. i will tell you what you want to know.