1967 Ford Mustang

sub compact Convertible

200 CU 6 cykinder

Manual

Rebuilt, Rebuildable & Reconstructed

Gasoline

NO TITLE. BILL OF SALE ONLY. Ebay doesn't have bill of sale as a title option so I entered reconstructed or rebuilt as that option. THIS VEHICLE IS LOCATED AT ME ROSEMOUNT MN 55068 HOME AND NOT IN LAS VEGAS AS THE TOP OF THE PAGE SAYS. Ebay won't let me change the location as my account is linked to the Las Vegas address. This is a very complete 1967 Mustang convertible. It has a 200 cubic inch 6 cyl engine with 3 speed manual transmission. I can only assume the engine is locked up but I would assume the new owner will convert to a V8 anyhow. YES this Mustang HAS RUST ! It's weird rust though. Some places that are usually rusted are not! Both front torque boxes are GOOD! All the frame rails , front and rear, are GOOD. The battery tray and right front fender apron are GOOD! The floors and inner rockers are BAD. You can repair the inner rockers and replace the floors. YES the car is sagging a bit in the middle and the doors do hit the rear quarters a bit but both doors still open and close. Both hood hinge inner fenders need replacing. The only body panel the I would use is the right fender and both headlight buckets and rear quarter extensions. The doors and rear quarters and left fender are too rusty to use in my opinion but I'm sure some of you out there would repair some of them. The hood and trunk are rusted on the bottom side but the hood does have the signal light option and all those parts are complete! I have lots of pictures but could only put 24 in the listing. I figure my verbal description is better than any pics. The rear frame rails are good too. The top of the trunk floors had a ton of tar put on them but they are good. The last owner tacked a piece of tin on each rear trunk floor sides so that nothing would fall into the lower quarter panel. All of the main structure pieces with the exception of the inner rocker panels are good. I honestly would spread the car to get doors fitting and then repair or reinforce the inner rocker panels. They are rusted on the bottom half but good from middle up. The rear black interior quarter trim panels are actually in pretty nice shape. Of course the seats need to be redone as well as a new top and top pads. It has a manual convertible top. The front grille is pretty nice and the moldings and trim look use-able. All in all this is a very complete and rebuild able 1967 Mustang Convertible. The rust issues it has may look bad to some but it's far better than most old Mustang Convertibles that have been sitting in a dirt floor barn for 30 plus years. As I stated earlier there is NO TITLE for this old Pony but most states are pretty friendly to giving you a title with a Bill of Sale and your Ebay proof of purchase as the receipt . I have tried to give a very descriptive description of this old Pony but if you need to call me my cell is 763-291-0343 Car is located in Rosemount MN 55068 and it is the buyer responsibility to make all shipping arrangements and get their own shipping quotes. CAR IS SOLD AS IS. NO WARRANTIES EXPRESSED OR IMPLIED BY THE SELLER. On Aug-05-17 at 23:12:25 PDT, seller added the following information: Just for your information I got called to my Las Vegas home and won't be back at my Minnesota home until 8/17/2017. The car will not be available for transportation until I get back on the 17th of August. If you have already bid and this date won't work for you then please retract your bid. I will expect the winning bidder to still pay the $1,000 deposit within 48 hours of auctions end. Thanks for understanding and HAVE A GREAT DAY! :-)