1990 Porsche 911

Coupe

Manual

WP0AB2961LS451545

Clear

1990 964 C2. Well maintained and has lived in Florida for the past ten years. Two Owner's prior and I have the majority of maintenance documentation prior to our purchase. Since then there has been routine maintenance, oil, transmission, brakefluid/pads, etc.. Other than that, the sunroof and ignition switch have been the only other repairs made. Ten years of hassle freeownership - Runs strong and is in excellent mechanical condition. Motor was recently removed from car and the following completed: - New Sachs clutch kit/slave cylinder/release bearing fork/needle bearing/clutch fork shaft seal - New engine covers- New crankshaft seal- New flywheel pilot bearing and seal- New oil bridge chain tensioner- New manifold gaskets- New valve covers and gaskets- New crankcase breather cover gasket- New brake discs and pads- New o-rings for oil return tubes- New oxygen sensor- New fuel filter- New spark plugs and wires- New distributor caps, rotors - New alternator, power steering and air conditioning belts- Shift linkage cleaned, bushings replaced and lubricated.- Other misc. bolts, fasteners, etc.. that needed to be replaced - everything was gone through and throughly cleaned also.- Note: Motor has a very small oil leak - we are talking a few drops in a week - not coming from case. We believeit may be a seal between the one of the cylinders and the block but did not want to pull the entire motor apart. Other than that, this motor is strong and mechanically sound - full disclosure. Additional service recently completed:- New outer CV joints, rear- Transmission, motor oil, brake fluids changed as well as coolant flushed and replaced.- New Zimmerman brake discs and Texstar pads/dampers Only upgrades on the car are a GHL exhaust system and Bilstein coilover suspension Tires are Michelin PS2 with approx. 50% tread Email with any questions.