1967 Ford Mustang

Coupe

289

Automatic

7T01C293210

Clear

Gasoline

0 false 18 pt 18 pt 0 0 false false false You are bidding on a 1967 Ford Mustang Coupe Project Car that starts with a clean title. It has a rebuilt 289 V8 engine with 0 (zero) driving miles on it. The engine cylinders have been bored .30 over and have hardened valve seats installed in the cylinder heads for unleaded gas. It has an Elderbrock Performer intake, Elderbrock 2122 camshaft/lifters kit and timing chain installed. It has a stock C4 automatic transmission. This vehicle has: · Electronic points · Motorcraft 4 barrel dual bowl carburetor · New dual 2-1/4 exhaust system with “H” pipe · New fuel tank and sending unit · New fuel pump · New alternator · New starter · New upper and lower radiator hoses The radiator support, battery firewall and drivers floor pan have been replaced. The manual front drum brakes were converted to power disc brakes from a 1978 Ford Granada. This mustang was manufactured with factory A/C. All parts are included but not installed. Some A/C parts needs replacement. The center console comes with the car. The car is complete with the exception of: · Front and rear bumpers · Dash pad · Carpet · Headliner Many parts need’s to be installed.There is some rust in various places on the vehicle that needs addressing. The driver’s door lock needs replacement and the left quarter panel needs bodywork/alignment. It can be driven onto a trailer or flatbed.Serious Bidders Only. A $250.00 deposit is due within 48 hours after auction closes and the balance is due 3 days after auction closes. Buyer is responsible for Pick-up or Shipping arrangement.Please contact me through eBay if you have any questions.Good Luck with your bidding.