1993 Chevrolet C/K Pickup 2500

TRUCK

5.7 litre

Automatic

1GCGK24K2PE129564

Clear

Gasoline

For sale is my 1993 Chevrolet K2500. This truck has been in my family for a long time, not sure exactly how long. I bought it from my great uncles estate. Since I bought it I have invested an estimated $9200.00 in repairs and rebuilding costs. The truck has had the following replaced: New350 motor from a local Chevy Dealer. All new engine accessories (except A/C compressor) New injectors, distributor , o2 sensor and oil cooler lines. Exhaust with free flowing catalytic converters and mufflers. Rebuilt trans, Transfer case and rear end and shocks. New 94 and up GMC grille with a billet insert. Installed correctly with new bumper fillers, brackets lower deflector. All factory GM parts. New front and rear bumpers, and grille guard. New reciever hitch with electric trailer brakes. New front and rear brakes and front hoses. New U joints. New custom leather seat and Grant steering wheel, Kenwood stereo and speakers. A/C works great and has R12 refrigerant. All gauges work, cigarette lighter also works fine. New wheels and tires. I replaced the front headlights and turn signal lenses. I have replaced all pins and bushings in the doors as well as the door latches. These doors open and close like they did 20 years ago. Also, this truck has a fold down goose neck hitch. I installed a tilt wheel column with new key tumbler and ignition swich. New steering box with pitman arm, idler arm and intermediate shaft. The ball joints, and inner and outer tie rod ends and A frame bushings, were good. This vehicle still needs a nice paint job. The body has NO RUST damage but, it has minor surface rust on the roof, but due to body damage, I had to replace the bed and tailgate. This truck was a ranch truck for most all of its life and there is a little bit of damage still to fix. The damage is all cosmetic tho. The antenna probably needs to be re wired as the signal is weak. it has a crack in the passenger side door panel. I have the original bench seat that will go with the truck. The sliding rear window also needs a latch. One of the only few items that I have not replaced is the fuel pump. I still works great. I have ALOT of money tied up in this truck. Unfortunatly for me I know I wont get it back. So my loss could be your gain. I have another project that I want to invest in, so this truck must go. I have probably left out something as I have done so much to it. please feel free to contact me if you have any questions, call Chad at 817-360-7522.