1923 Ford

T-Bucket Other

8 - Cyl.

Automatic

184510

Clear

Gasoline

1923 Ford fiberglass T-Bucket with opening passenger door. 1923 Ford title with 6 digit VIN. Custom built frame. Steel floor board and firewall. Over $8000.00 in new parts. 360 Mopar engine. Spare 360 to go with it. 727 Torqueflight transmission - Ford rear end and front axle. Over 90% of the new parts are there. Just about all the parts you should need would be rear shocks, steering coupler, u-joint, and gasket set. Needs various brackets welded on frame, rear end, and front end and it all put together. This is not a “roller” because brackets need to be welded. Many new CHROME and STAINLESS parts to be installed include: oil pan-oil filter cover-transmission pan-alternator-starter-coil (Accel)-fuel pump-head lights-floor mount E-brake lever-Panhard bar-Cragar wire spoke wheels- front friction shocks-Sanderson headers-Mr. Gasket Street Scoop II-fan shroud -flex fan -dip stick- March stainless steel pulley set- front and rear stainless polished radius rods-ARP bolt sets-clevises-jam nuts-shackles-spring perch Other new parts include: Weiand Stealth intake-Holley 750 double pumper-B&M converter and flex plate-Crane Energizer cam (D=272 L=.454”) & kit with chrome moly pushrods-Mopar roller timing chain set & electronic ignition-Ron Francis Wireworks fuse block kit-Stewart Warner Wings gauges (set of 6)-Grant foam steering wheel-B&M Quicksilver shifter-BF Goodrich tires (195x60x15 on front and 295x50x15 on back)-Omni rack and pinion steering-Moroso super wire loom kit-remote oil filter kit-Mopar master cylinder. Also have: Set of '63 Chevy tail lights-steel rear fenders-glass pack mufflers-pressure and proportioning valves-windshield wiper-horn-windshield and support rods-seat belts-variety of books Have '68 Mustang and 10 gal. rectangle gas tanks. I was going to build a wooden box to fit the Mustang tank. Home made pick-up box. I started to rebuild the whole car with all this new stuff and I had a heart attack. Now, I have a bad back, too, so I'm giving it up. MUST PICK UP. Can't be shipped. Must be hauled. Can be rolled on a trailer, but IS NOT a "roller" because brackets need to be welded. I am selling this car in "AS IS" condition. Within 48 hours of winning bid/ end of auction, buyer must contact seller to make payment and pickup arrangements. I also require a $500 non-refundable deposit within 48 hours. Full payment required within 7 days of auction close. Must be paid in full and money cleared before vehicle is released. Buyer is responsible for all pickup, transport, or delivery fees.